More

  • Converter Slag Of Steel In Clinker Production

    Sun Converter Slag Of Steel In Clinker Production. Producing portland cement from iron and steel slags and limestone the clinker is cooled crushed almost the same amount of converter slag production of about 600000 tons per year and more than 10 million tons in stock exists in the mill and is increased daily. Free Quotation

    MORE
  • Utilization of steel slag for Portland cement clinker ...

    2008-4-1 · The steel slag was mixed with other raw materials, such as limestone, clay, sand, and bauxite, in appropriate proportions in order to produce the raw meal to be tested for the production of Portland cement clinker ((PC) S/S).A reference raw meal ((PC) Ref), without steel slag, was also synthesized for reasons of comparison.The chemical analyses of the raw materials used

    MORE
  • Utilization of steel slag for Portland cement clinker ...

    mainly of steel slag, blast furnace slag and Portland cement, has. been commercially marketed in China for more than 20 years. and uses

    MORE
  • Benefits of using steel slag in cement clinker production ...

    2021-2-1 · The substitution of iron ore with steel slag in clinker production provides an environmentally friendly modification to the manufacturing process. During production, using steel slag as the raw material can reduce CO 2 emissions, fossil fuel combustion, and power consumption. In experimental studies, increasing the substitution amount of steel ...

    MORE
  • Producing Portland cement from iron and steel slags and ...

    1999-9-1 · The slags from blast furnace (iron making ) and converter (steel making) after magnetic separation are mixed with limestone of six different compositions. The ground materials are fired in a pilot plant scale rotary kiln to 1350 °C for 1 h. The clinker is cooled, crushed, mixed with 3% gypsum, and ground to fineness of more than 3300 cm 2 /g.

    MORE
  • Utilization of steel slag for Portland cement clinker ...

    2020-1-3 · However, a specialty steel slag cement, which is composed mainly of steel slag, blast furnace slag and Portland cement, has been commercially marketed in China for more than 20 years and uses approximately 40% of the total steel slag production [7]. This type of cement has the advantages of lower energy

    MORE
  • (PDF) Development of converter operation technology

    Development of converter operation technology using ironbearing concentrates and clinker-steel cakes September 2016 IOP Conference Series Materials Science and Engineering 150(1):012009

    MORE
  • Method for cement clinker production using vitrified slag

    2002-7-2 · A method for the production of cement clinker comprises the introduction of vitrified slag into the feedstock stream prior to the clinkering zone. The addition of vitrified slag can increase the clinker output rates and/or reduce the energy requirements for maintaining the kiln temperatures. In one embodiment, the vitrified slag is a vitrified blast furnace slag.

    MORE
  • Steel Slag - an overview | ScienceDirect Topics

    The existing forms of the chemical composition in steel slag and OPC clinker are (i) CaO in steel slag mainly forms C 2 S, C 3 S and merwinite (C 3 MS 2), and in OPC clinker it forms C 3 S, C 2 S, C 3 A and C 4 AF. (ii) Aluminum oxide (Al 2 O 3) content in steel slag exists in solid solution. In OPC clinker, Al 2 O 3 forms calcium aluminate and ...

    MORE
  • Slag recycling - recovery

    The increasing global and local imbalances in slag production, slag recovery and recycling have led to a rise in global trade flows. According to the World Steel Association, about 25 Mta of slag is traded across national borders worldwide, 12 Mta alone concern exports from Japan and 5 to 6 Mta relate to exports from China.

    MORE
  • System assessment of recycling of steel slag in converter ...

    2016-4-7 · System assessment of recycling of steel slag in converter Journal of Cleaner Production ( IF 9.297) Pub Date : 2016-04-07, DOI: 10.1016/j.jclepro.2016.03.040 Jiang Diao, Wang Zhou, Zhaoqun Ke, Yong Qiao, Tao Zhang, Xuan Liu, Bing Xie

    MORE
  • (PDF) Development of converter operation technology

    Development of converter operation technology using ironbearing concentrates and clinker-steel cakes September 2016 IOP Conference Series Materials Science and Engineering 150(1):012009

    MORE
  • Experimental Investigation on the Effect of Converter Slag ...

    2021-12-9 · Converter slag is a by-product of steelmaking produced during the conversion of pig iron into steel in a basic oxygen furnace. This solid waste has variable oxide composition with a high amount of CaO, Fe 2 O 3 with minor oxides of SiO 2, and MgO [ 16 ], which are also present in ordinary Portland Cement (OPC).

    MORE
  • Utilization of Linz–Donawitz slag from steel industry for ...

    2020-1-27 · The non-metallic phase can be used for production of Portland clinker. However, above conversion requires very high temperature of 1500 °C. Takeuchi et al. [] have removed 60% of phosphorus from the slag using Fe–Si alloys as the reducing agent to P 2.Phosphorus extraction behaviour from Fe–P–C satd alloy at 1200 °C was also investigated by Morita et al. [].

    MORE
  • Ladle metallurgy stainless steel slag as a raw material in ...

    Steel slag applications in clinker production, as an aggregate in concrete and mortar, as constituent material in all pavement layers (unbound,

    MORE
  • Utilization of converter steel slag by remelting and ...

    Utilization of converter steel slag by remelting and reducing treatment. Jiao Ma 1, Yibo Zhang 1, Tianqi Hu 1 and Shushan Sun 1. Published 1 July 2018 • Published under licence by IOP Publishing Ltd IOP Conference Series: Materials Science and Engineering, Volume 382, Issue 2

    MORE
  • Fly ash and Blast Furnace Slag for Cement Manufacturing

    2017-11-20 · (Partial) substitution of clinker in cement production or (partial) substitution of cement in concrete production reduces these CO2 emissions, especially if material is used which is seen as a waste of other processes, such as Fly Ash (FA) from coal power plants and Granulated Blast Furnace Slag (GBFS) from the iron and steel sector.

    MORE
  • Upgrade - Slag industry news from Global Slag

    2019-11-28 · Netherlands: India-based Tata Steel has announced a planned total investment of Euro300m in environmental upgrades to its IJmuiden, Noord Holland plant. The upgrades include a Euro150m nitrous oxides control (DeNO x) plant at its pellet plant and a Euro50m odour, particulate emissions reduction modernisation of a coke and gas plant and projects to dust

    MORE
  • Manufacturing Process Of Steel - Properties Fabrication ...

    2020-7-3 · Converter carryover slag – during primary steel refining in the BOS / EAF converter, slag-making additions are made to form a slag which absorbs impurities from the steel (such as sulphur and phosphorus). During converter tapping, in addition to the crude steel tapped into the ladle, some converter slag is also carried over into the ...

    MORE
  • Research on Enrichment of MFe and RO Phase from

    A new approach to enrich MFe and RO phase from the converter slag by super gravity was investigated. The samples obtained by the gravity coefficient G=600 and cooling rate V=5K/min from 1623K to 1373K appeared significant stratification and the MFe gathered at the bottom of sample. With the help of metallographic microscopy and X-ray ...

    MORE
  • System assessment of recycling of steel slag in converter ...

    2016-4-7 · System assessment of recycling of steel slag in converter Journal of Cleaner Production ( IF 9.297) Pub Date : 2016-04-07, DOI: 10.1016/j.jclepro.2016.03.040 Jiang Diao, Wang Zhou, Zhaoqun Ke, Yong Qiao, Tao Zhang, Xuan Liu, Bing Xie

    MORE
  • Utilization of Linz–Donawitz slag from steel industry for ...

    2020-1-27 · The non-metallic phase can be used for production of Portland clinker. However, above conversion requires very high temperature of 1500 °C. Takeuchi et al. [] have removed 60% of phosphorus from the slag using Fe–Si alloys as the reducing agent to P 2.Phosphorus extraction behaviour from Fe–P–C satd alloy at 1200 °C was also investigated by Morita et al. [].

    MORE
  • Steel-slag: a supplementary cementious material and basis ...

    2011-7-1 · Steel-slag with alkalinity greater than 1.8 is usually recommended. 2. Steel-slag can be used to produce energy-saving cement by co-grinding with OPC clinker and blastfurnace slag. In such preparations OPC clinker is about 15-30%, steel-slag around 30-40% and blastfurnace slag is around 40-50%. 3.

    MORE
  • Utilization of converter steel slag by remelting and ...

    Utilization of converter steel slag by remelting and reducing treatment. Jiao Ma 1, Yibo Zhang 1, Tianqi Hu 1 and Shushan Sun 1. Published 1 July 2018 • Published under licence by IOP Publishing Ltd IOP Conference Series: Materials Science and Engineering, Volume 382, Issue 2

    MORE
  • The carbon cost of Slag production in the blast furnace

    2019-11-27 · 16/4/2015 4th Slag valorization symposium Leuven 7 Low CO2 values for GBFS should lead to an obligation to use GBFS over clinker for the cement user but also to a decrease of production for the steel maker since the steel footprint is too high =>

    MORE
  • Upgrade - Slag industry news from Global Slag

    2019-11-28 · Netherlands: India-based Tata Steel has announced a planned total investment of Euro300m in environmental upgrades to its IJmuiden, Noord Holland plant. The upgrades include a Euro150m nitrous oxides control (DeNO x) plant at its pellet plant and a Euro50m odour, particulate emissions reduction modernisation of a coke and gas plant and projects to dust

    MORE
  • Generation of iron and steel slag : NIPPON SLAG

    2020-10-18 · Steelmaking slag is generated by the process that turns pig iron produced by a blast furnace into tough and highly workable steel. Converter slag is the oxidized material that is generated when lime and other auxiliary materials

    MORE
  • Research on Enrichment of MFe and RO Phase from

    A new approach to enrich MFe and RO phase from the converter slag by super gravity was investigated. The samples obtained by the gravity coefficient G=600 and cooling rate V=5K/min from 1623K to 1373K appeared significant stratification and the MFe gathered at the bottom of sample. With the help of metallographic microscopy and X-ray ...

    MORE
  • Portland cement manufacture from slag from the

    The clinker is cooled, ground to a powder, and blended the clinker with powdered gypsum to form the Portland cement. White Portland cement may be produced by removing iron containing compounds from the slag, minimizing contamination of the material by iron compounds throughout the process, and cooling the clinker in a manner that minimizes ...

    MORE
  • Comprehensive Utilization Technology of Steel Slag ...

    2019-5-23 · Abstract. The deposit volume of steel slag in China exceeds 400 million tons, leading to the occupation of a large area of land and serious environment pollution. However, the current utilization rate of steel slag in China is only about 21%,

    MORE

About Us

LTD which mainly manufacture large and medium-sized crushing and grinding equipments was founded in 1987. It is a modern joint-stock corporation with research, manufacturing and sales together.

Over the more than 30 years, our company adheres to modern scientific management system, precision manufacturing, pioneering and innovation. Now LIMING has become the leader in domestic and oversea machinery manufacturing industry.

read more

Contact us

Thank you for your interests in Liming Heavy Industry. Please feel free to submit your inquiry information to us. our sales manager will contact with you as soon as possible.

Email: [email protected]